5/27
We were tasked with making a micro controlled power supply in order to control the speed of our motor. To do this we need one 22uF capacitor, two 1000uF capacitors, one inductor, one 10k resistor, two 100k resistors, two diodes, and an Opamp. We set up the micro controlled power supply in a circuit but were unable to complete it because some items were not in stock.
The above picture is what the final product will look like.
link to micro controller project: http://www.instructables.com/id/Variable-0-12V-Digitally-Controlled-Power-Supply-u/step8/Connect-Laptop-Adapter/
ReplyDeleteDay 1 5/27/16:
In addition to what Nico posted: a power supply was found, stripped and fitted to a Jameco ValuePro board and a bread board. The DC voltage from the power supply is 19.8 V read by an Innova 3320 Multimeter.
Previously in that day, we could not connect an Arduino Due to Simulink.